Section III - Instructions to configure ApacheDS and load with seed data
Quickstart ApacheDS - Table of contents
Section V - Instructions to install Commander Web UI Demo

Section IV - Instructions to regression test Fortress and ApacheDS on target machine (optional)

Step 1

From FORTRESS_HOME root folder, enter the following command from a system prompt:

./b.sh test-full

Screenshot

Note: The Fortress regression tests will run for around 3 minutes.

Step 2

Verify these tests ran with no ERRORS.

BUILD SUCCESSFUL

Screenshot

Step 3

To re-run these tests: 

./b.sh test-full
WARNING messages in test output are good as these are negative tests in action.

Screenshot

If you made it this far without junit or ant ERRORS, the Fortress and ApacheDS IAM system are certified to run on your machine.
These tests load tens of thousands of records into your newly installed directory. The 'init-apacheds' and 'test-full' targets may be re-run as often as necessary. After regressions testing has completed, you may run the 'init-apacheds' target to remove all test data from the directory.
Section III - Instructions to configure ApacheDS and load with seed data
Quickstart ApacheDS - Table of contents
Section V - Instructions to install Commander Web UI Demo