This bundle tries to be complaint to the UPnP Base Driver OSGi R4 specification.

At the moment the bundle do not support the following requirement:
 - upnp.ssdp.address Configuration Service
 - exported device changes: if a service already exported as UPnP Device changes 
   it's own configuration, i.e.: implements new service, changes the friendly name, etc.,
   the new service description is not reflected on the UPnP Device
 - icon for exported device is not tested
 - no localization support

The bundle provides extra capabilities:
 - the bundles implements the org.apache.felix.upnp.extra.controller specification

Finally the bundle can be configured by setting the following properties divided by categories:
1 - LOGGING
felix.upnpbase.log: integer which identifies the verbosity of the bundle
felix.upnpbase.cyberdomo.log: boolean which enables or disables the UPnP CyberDomo SDK debugging messages
2 - FACILITY
felix.upnpbase.exporter.enabled: boolean which enables or disables the Exporter facilities of the UPnP Base Driver
felix.upnpbase.importer.enabled: boolean which enables or disables the Exporter facilities of the UPnP Base Driver
3 - NETWORK 
felix.upnpbase.cyberdomo.net.loopback: boolean which enables or disables the use of Loopback devices
felix.upnpbase.cyberdomo.net.onlyIPV4: boolean which enables or disables the use of IPv4 addresses
felix.upnpbase.cyberdomo.net.onlyIPV6: boolean which enables or disables the use of IPv6 addresses (if base driver is running on JDK 1.4 or greater)
cyberdomo.ssdp.mx: integer which idntifies the value to set in MX packet while performing discovery operation on UPnP
cyberdomo.ssdp.buffersize: integer which identifies buffer size for UDP packet
cyberdomo.ssdp.port: integer which identifies the destination port to use for SDDP multicast discovery packet